lish – 19
Driving
Cutting tips
• Localise and mark stones and other fixed objects to avoid
collision.
• Start with a high cutting height and reduce down until the
required mowing results are obtained.
• The mowing results are best with a high engine speed
(fast rotating blades) and low driving speed (slow moving
machine). If the grass is not too high and thick, the driving
speed can be increased without noticeably depreciating
the mowing result.
• The best lawns are achieved if the grass is cut often.
Mowing becomes more uniform and the grass cuttings
become more evenly distributed over the surface. The
total time consumption is not greater since it is possible to
select a higher driving speed without inferior mowing
results.
• Avoid mowing a wet lawn. The mowing results are inferior
since the wheels sink down into the soft lawn.
• Hose down the cutting unit with water underneath each
time it is used. The cutting unit should then be put in the
service position.
• When the Mulching function is used, it is very important
that the mowing interval is not too long.
Starting on a slope, manual gearbox
For FR 2211 R and FR 2211 M
1 Press down the parking brake pedal.
2 Push the throttle control to full throttle position.
3 Disengage the engine and select 1st gear.
4 Gradually release the clutch pedal.
5 When the engine starts to pull, release the parking brake.
Stop the engine
Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard.
1 Lift up the cutting unit by pulling the lever backwards to its
locked position.
2 For FR 2211 R and FR 2211 M
Pull back the throttle and move the gear shift lever to the
neutral position ”N”, without pressing in the reversing lock
button. Turn the ignition key to the ”STOP”.
3 For FR 2213 MA, FR 2216 A and FR 2216 A2
Pull back the throttle and turn the ignition key to the
”STOP” position.
4 When the Rider is at a standstill, press down the parking
brake and push in the locking button.
Release lever
For FR 2213 MA, FR 2216 A and FR 2216 A2
The release control must be pulled out in order for the
machine to be moved when the engine is shutoff.
Pull the controls to the end positions, do not use an
intermediate position.
• Control drawn out, drive system disengaged.
• Control depressed, drive system engaged.
!
WARNING! Clear the lawn from stones and
other objects which can be thrown out by
the blades.
!
WARNING! Do not use the machine on
ground that slopes more than 10
°°
°°
..
..
Mow
slopes upwards and downwards, never
across. Avoid sudden changes in direction.
STOP
START
To Next Page
Loading...
