English – 15
DRIVING
!
Stopping the engine
Preferably allow the engine to idle for a minute to
obtain normal working temperature before stopping
it if it has been working hard.
1. Lift up the cutting unit by pulling the lever back to
the end position.
2. Pull back the throttle control and turn the ignition
key to the STOP position.
STOP START
Release lever
In order to move the machine when the engine is
switched off the release lever must be pressed
down and forwards.
WARNING!
Never drive the machine on ground
with a slope of more than 15°. Mow
slopes upwards and downwards,
never across. Avoid sudden changes
in direction.
To Next Page
Loading...
