— 4 —
OPERATING YOUR APPLIANCES
BY CLAPPING
How to operate an appliance with 2 claps:
1. Slide the Home/Away switch to the Home position.
2. Turn the dial up (Counter Clockwise) to the highest
sensitivity setting(# 9).
a. Adjust it down to reduce the Clapper from
detecting unwanted noise
3. Plug an appliance into the top receptacle (II) of The
Clapper Plus.
4. Plug the Clapper Plus into the wall socket.
5. Make sure any power switches on the appliance or lamps
are in the on position.
6. You can now turn your appliance on and off by clapping.
You don’t have to clap very hard! The clapping sequence is
more important than how loudly you clap.
CLAP (pause) CLAP (pause) (pause) (pause)
where each pause is approximately ½ second long. The
three pauses after the second clap are very important since
the Clapper Plus must determine that you are not going to
clap a third time. If you did clap a third time, the appliance
connected to the III clap receptacle would activate..
To Next Page
Loading...
Need help?
General