— 5—
HOW TO OPERATE AN APPLIANCE
WITH 3 CLAPS:
1. Slide the Home/Away switch to the Home position.
2. Turn the dial up (Counter Clockwise) to the highest
sensitivity setting(# 9).
a. Adjust it down to reduce the Clapper
from detecting unwanted noise.
3. Plug an appliance into bottom receptacle (III)
of the Clapper Plus.
4. Plug Clapper Plus into the wall socket.
5. Make sure any power switches on the appliance
or lamps are in the on position.
6. You can now turn your appliance on and off by clapping.
You don’t have to clap very hard. The clapping sequence
is more important than how loudly you clap:
CLAP (pause) CLAP (pause) CLAP (pause)
where each pause is approximately ½ second long. The
last pause after the third clap is very important since the
Clapper Plus must determine if you are not going to clap
a fourth time. If you did clap a fourth time, the appliance
would not activate.
To Next Page
Loading...
Need help?
General