— 7—
appliance attached to the “II Clap side.” If a third clap is
detected, then the third light will glow and the appliance
connected to the “III Clap Side” will activate.
OPERATING YOUR APPLIANCES
USING THE REMOTE CONTROL
Installing the remote switch battery
1. Remove battery cover by using a coin and turn clockwise.
2. Insert the included C2032 Lithium battery positive (+)
side facing toward you.
3. Replace the battery cover. Use a coin and turn
counter-clockwise to lock the cover.
Operating your appliance with the remote
1. Set the sensitivity dial to the best position for
the room you are in (as described above).
2. Plug an appliance into Top or Bottom receptacle
of the Clapper Plus.
3. Plug the Clapper Plus into the wall socket.
4. Make sure any power switches on the appliance
or lamps are in the on position.
5. Now you can use the remote switch or clap to turn
the appliances on or off.
To Next Page
Loading...
Need help?
General