— 9—
THE AWAY MODE
When in the AWAY mode, both appliances will turn on
with the detection of any sound.
To operate The Clapper Plus in the AWAY mode
1. Slide the Home/Away switch to the Away position. Both
attached lamps will turn on for 10 seconds. is allows
you to leave the room with the lights on.
2. Aer the 10 seconds the lights turn o and the
Clapper Plus is ready to detect any noise.
3. e Le Red clap detection light will blink to
indicate the Clapper is in the Away Mode.
4. When the Clapper detects a sound your appliances will turn
on and remain on for about 10 minutes and then turn off.
The Clapper will then reset itself until the next sound is heard.
5. Set the sensitivity dial to the best position for the level
of noise you want to detect ( #9 Most sensitive, #1 Least
Sensitive).
TIPS
• Start at the lowest sensitivity by turning sensitivity dial
clockwise to #1 and then increase the sensitivity to the
level you desire.
• Sliding the Home/Away switch from “Away to Home and
To Next Page
Loading...
Need help?
General