— 8 —
Press, hold and release the II button to turn on the
appliance plugged into the Top (II receptacle) of the
Clapper Plus. Press it again to turn it off.
Press, hold and release the III button to turn on appliance
plugged into the bottom (III receptacle) of the Clapper.
Press it again to turn it off.
Double Sided Tape
The remote can be attached to your wall or dresser using
the special tape included. Attach the tape on the back of the
remote. The adhesive allows for repositioning and
removes cleanly from most painted surfaces without damage.
If the tape does not stick anymore it can be rejuvenated by
wiping it clean with water.
Place a small amount of water on your nger tip. Wipe
the tape clean and allow to air dry. This can be repeated as
many times as needed.
Key Ring
The wire key ring (enclosed) can be attached to the end of
the remote to make the remote more portable. Connect to a
keychain and be able to turn on your lights as you are enter-
ing your house, or use a safety pin to attach to your clothing
To Next Page
Loading...
Need help?
General