Start engine
1. Engage the park brake
2. Press the clutch pedal
down, put the shift lever
in neutral
3. Insert the key into the
Ignition-switch
If the engine is cold
1. Pull the choke out fully
2. Press down the clutch pedal
3. Turn the key clockwise to the “on” position. Release the key and the clutch pedal
when the engine starts.
4. Push the choke back slowly to allow the engine to run smoothly. Keep engine
running for 1-2 minutes.
5. Push the choke back fully. If the idle of engine is not smooth, pull out the choke to
find the best running position and keep running for a while long until the engine runs
smooth without choke.
If the engine is warm
Press the throttle slightly and turn the key clockwise to the “on” position, release the
key and the throttle when the engine starts.
Speedome Tachomete
Horn
Coolant temperature
Voltmete
Fuel level gauge
Accelerator
Brake pedal
Clutch pedal
Shift lever
Steering wheel
Speedome Tachomet Horn
Coolant temperature
Voltmete
Fuel level gauge
Combination switch
To Next Page
