ages) associated with the direction, proceed with Step 3 below.
If you want the same throws associated with a direction that is
specified more than once, go directly to Step 4 below.
3. In order to specify different throw for the same direction; touch
the SEL key under the appropriate Flight Mode to indicate
either P-0 or P-1. Remember there is a limit of two sets of
throws for each direction. The Flight Modes designated as P-0
for a given direction will have one set of throws, while the
Flight Modes designated as P-1 for the same direction will
have another set of throws. Proceed to Step 4 below.
4. It’s now time to set the throws (percentages) for the directions
that have been established for each Flight Mode. Touch PAGE
to return to the previous screen where the percentages are dis-
played and can be adjusted.
5. Set the Flight Mode switch to FM-0. Notice that the direction
that was set for FM-0 on the previous screen is highlighted. Set
the percentages of travel for the aileron, elevator and rudder
using the + and - keys. These are now the settings for Flight
Mode 0. Next move the Flight Mode switch to FM-1 and set
the percentages in the same fashion as described above for
FM-0. Repeat the process for FM-2 through FM-4.
10X MANUAL Airplane
37
To Next Page
Loading...
Need help?
General
