Timer
The 10X has both an integrated timer and a count-down timing
feature. The integrated timer serves as an up-timer, displaying the
accumulated transmitter on time for each model in the transmit-
ter’s memory. The count-down feature is used as a stopwatch for
timed flights.
Accessing the Integrated Timing Function
To access the Integrated Timing function, enter Code 87 at the
code number access selection or use the direct mode method.
The screen will display:
Integrated Timer
The integrated timer displays the total time the transmitter has
been on for each model. After 60 hours, the integrated timer auto-
matically resets to 0:00:00. There are two screens where the inte-
grated timer can be viewed:
1) in Code 87, timer function, as mentioned previously, and
2) in the initial display screen.
This screen will appear as follows:
While you are in the Timer function, you can reset the integrated
timer by pressing the CL key. The timer returns to 0:00:00
momentarily and begins counting once again.
Note: The timer also resets if Code 28, Data Reset, has been
used.
The Count-Down Timer
This is the left-half of the screen. To activate the count-down tim-
ing feature, touch the ACT key. Your display changes to show
that it has been activated.
To adjust the time for the count-down timer, press the + and/or -
keys. From left to right on the timer display they: 1) add minutes
to the timer in one (1) minute intervals up to 60 minutes,
2) subtract minutes from the timer in one (1) minute intervals to
00 minutes,
3) add seconds to the timer in ten (10) second increments up to
50 seconds.
Once the count-down timer has been set to the proper time, press
the ENTER key to memorize the settings and exit the program.
To view your count-down timer settings, return to the initial
screen of the PCM10X.
The screen should now show:
Note: If the count-down timer is left at 0:00, zero, and active,
you may use it as a stopwatch or count-up timer.
Use of the Count-Down Timer
Touch the ST/SP key to start or stop the count-down timer. This
also serves to activate the stopwatch when the timer is set to 0:00,
zero.
Touch the CL key to reset the count-down timer to the pre-select-
ed time.
During the count-down, the timer beeps twice at each minute
until it reaches the 30 seconds remaining mark, when it beeps
three times. At each ten (10) second interval afterwards, it beeps
twice until it reaches the final ten (10) seconds. It then beeps once
for each second until zero (0) time remains, when it sounds one
long beep. Once the timer has reached the zero, the display shows
+ to the right side of the time count. It then begins to count
upwards as elapsed time.
66
10X MANUAL Airplane
8.27
Code 87
To Next Page
Loading...
Need help?
General
