JR XP652 User Manual

6-CHANNEL COMPUTER RADIO
INSTRUCTION MANUAL
FOR AIRPLANE AND
HELICOPTER

JR XP652 Specifications

General

Brand	JR
Model	XP652
Category	Remote Control
Language	English

Summary

Airplane Section

Helicopter Section

Model Type Selection

Servo Reversing

Chapter 4: Battery Charging

4.1 Transmitter/Receiver

4.2 Charger

Chapter 5: Trainer System

5 Trainer System

Operating the Trainer System

Chapter 1: Transmitter Controls

1.1 Control Identification and Location

1.2 Receiver Channel Assignment/Transmitter Throttle ALT

Chapter 1: Transmitter Controls (Continued)

Chapter 2: Connections

2.1 Installation Requirements

Chapter 4: Battery Alarm and Display

4 Battery Alarm and Display

Chapter 5: Input Mode and Function

5.2 System Mode

Entering and navigating system mode functions.

Chapter 5: Input Mode and Function (Continued)

5.3 Function Mode

Entering and using function mode for adjustments.

Chapter 6: Functions

6.1 Model Type Selection

Selecting between airplane and helicopter modes.

Chapter 6: Functions (Continued)

6.2 Data Reset

Resetting model data to factory settings.

6.3 Dual Rate Switch Selection

Selecting switches for dual rate functions.

6.4 Wing Type Selection

Setting up flaperon, V-tail, or delta wing types.

6.5 Model Selection

Selecting and managing stored models.

6.7 Modulation Select

Selecting transmission modulation type.

6.8 Fail-Safe/Hold

Overview of fail-safe and hold functions for PCM.

Setting Fail-Safe/Hold Time Delay/Memory In Z-PCM Modulation

Setting time delays for fail-safe.

6.10 Fail-Safe/Hold Memory in S-PCM Modulation

Fail-safe/hold for S-PCM modulation.

6.4 Gear/Gyro Switch Selection

6.9 Fail-Safe/Hold Function in Z-PCM Modulation

Detailed fail-safe setup for Z-PCM.

Setting Servo Position Presets

Defining servo positions for fail-safe.

Chapter 7: Functions

7.1 Servo Reversing

Changing servo rotation direction.

7.11 Trim Offset Memory

Chapter 7: Functions (Continued)

7.2 Dual Rate

Setting two servo travel rates for flight.

7.3 Exponential

Adjusting control response rate for sensitivity.

7.4 Sub-Trim

Electronically adjusting servo neutral positions.

7.5 Travel Adjustment

Adjusting servo travel amount per direction.

7.6 Aileron to Rudder Mixing

Mixing aileron and rudder for coordinated turns.

7.7 Elevator to Flap Mixing

Mixing elevator and flap for pitching rate.

7.8 Differential

Correcting roll-yaw coupling with flaperon/delta wings.

7.9 Flap to Elevator Offset Trim

7.10 Programmable Mixing (A,B,C)

Assigning Channels

Mixing Value Adjustment

7.6 Throttle Hold

7.7 Pitch Curve

7.8 Throttle Curve

7.9 Revolution Mixing

7.10 Rudder Offset

7.11 Programmable Mixing (A)

7.12 Stunt Trim

7.13 CCPM Swashplate Mixing

Mixing Offset Adjustment

Chapter 7: Trim Offset Memory

Accessing the Offset Trim Clear Function

Accessing the Trim Offset Memory Function

Chapter 7: Trim Offset Memory (Continued)

Accessing the Trim Offset Memory Function (Continued)