JR XP652 - 7.8 Differential

Accessing the Differential Function
•
Flaperon/Delta Mode Only
MIX
DIF
0
%
DIFFERENTIAL VALUE (0 TO 100%)
INDICATES THE
DIFFERENTIAL FUNCTION
–
+
MODE
ENTER
CHANNEL INCREASE
CLEAR
DECREASE
Press the INCREASE or DECREASE
button to adjust the differential value.
Press the MODE button
until MIX DIF appears
on the screen.
Aileron differential is used to correct roll to yaw
coupling and adverse yaw characteristics. In order to
activate differential, the flaperon wing type must
have been selected in the system mode (see Section
6.4). Also, each aileron control surface must have its
own servo with the right aileron servo plugged into the
aileron channel (#2) on the receiver and the left aileron
servo plugged into the Flap Aux 1 channel (#6) on the
receiver.
1. Turn on the transmitter.
2. Flaperon wing type must be selected (see Section
6.4).
3. Press the MODE and CHANNEL buttons
simultaneously to enter the function mode.
4. Press the MODE button until MIX DIF appears on
the screen.
5. Press the INCREASE or DECREASE button to
adjust the differential mixing value.
6. Press the MODE button to access the flap to
elevator offset trim function.
7. To exit, press the MODE and CHANNEL buttons
simultaneously.
DIFFERENTIAL
•
Function Mode
7.8
43
XP652 MANUAL Airplane