Need help?Do you have a question about the JR 10X and is the answer not in the manual?
General| Brand | JR |
|---|---|
| Model | 10X |
| Category | Remote Control |
| Language | English |
Features of the transmitter, including flight modes, digital trims, and throttle trim.
Specifications and features of the NER 950S receiver.
Features and specifications of JR Digital Servos, including DS8231.
Details the overall system components for the 10X.
Lists technical specifications for the J120FS transmitter.
Provides specifications for the NES-8231 Digital Servo.
Details technical specifications for the NER-950S receiver.
Lists specifications for the NEC-222 charger.
Details specifications for the 1400 mAh Sanyo Extra NiCad battery.
Identifies all physical controls and switches on the transmitter.
Details controls and ports located on the rear of the transmitter.
Explains how to adjust the length of the control sticks.
Describes how to attach a neck strap for balance.
Guides on how to adjust the tension of the control sticks.
Offers suggestions for proper radio system installation in aircraft.
Illustrates wiring and connection diagrams for system components.
Provides guidelines for cleaning and maintaining the touch screen display.
Explains basic touch panel operations and key inputs.
Describes the low voltage battery alarm and its indicators.
Explains the alarm for lithium back-up battery failure.
Details how to access functions using code numbers.
Explains how to access functions via direct mode selection.
Explains how to electronically reverse servo throws for any channel.
Guides on adjusting servo travel limits for each channel.
Covers programming dual rates and exponential curves for flight controls.
Explains setting up standard programmable mixes between channels.
Explains how flight modes are assigned to switch positions.
Recommends a phased approach to programming and using flight modes.
Explains how to select throttle curves using switches or flight modes.
Describes the default wing type for aircraft with single aileron servo.
Explains using ailerons as flaps and their control setup.
Details assigning snap roll direction and rates to flight modes.
Explains how to connect gyros to the receiver ports.
Guides on accessing the basic gyro gain adjustment feature.
Explains assigning gyro gains to switches or flight modes.
Describes the stick priority feature for gyro gain override.
Guides on setting up standard programmable mixes between channels.
Guides on defining custom curves for slave channel response to master channel.
Explains assigning rudder-to-aileron/elevator mixing to switches/modes.
Allows programming flap/elevator positions for specific flight modes.
Details setting an auto land throttle position to retract flaps.
Guides on testing servos for wear by cycling their travel.
Explains the Hold function which stops servos at last signal position.
Details setting preset servo positions for signal loss conditions.
Explains using the 10X as the master in a buddy box setup.
Guides on adjusting digital trim sensitivity and rate.
Explains how to select and navigate through model memories.
Details transferring model memory between transmitters or PC.
Guides on preparing the transmitter for data transfer.
Details how to initiate the data transfer process.
Explains how to set and use the count-down timer.
Describes the transmitter's accumulated operating time display.
Guides on setting a three-digit code to protect transmitter settings.
Provides instructions for charging transmitter and receiver batteries.
Details proper usage and precautions for the supplied charger.
Details the limited warranty period and coverage for the radio system.
Provides instructions on how to send the unit for service.
To Next Page
