Important Note: Because of the travel limits built into most
gyros with remotely adjustable gain, it will be necessary to
reduce the Travel Adjust (Code 12) for the channel that’s affected
by the gyro in order to eliminate “dead band” from the control
stick.
To do this: With the model turned on, access Code 12. Hold the
control stick of the channel using the gyro to full left (or up in
case of elevator) and reduce the travel adjust until the control
surface begins to move. Then hold full right stick or elev and
repeat this process. Normally the travel adjust will have to be in
the 55% to 65% range to eliminate all stick dead band. Note that
this does not reduce the overall travel of the servo, but simply re-
calibrates the travel adjust for use with the gyro.
10X MANUAL Airplane
41
To Next Page
Loading...
Need help?
General
