4-41
4.19 SBAS RECEIVER SETTING
Set to a JRC’s SBAS receiver.
SBAS receiver use the information from satellite same as that of beacon which DGPS use. So the accuracy of position
is higher than GPS.
This setting is enabled when a JRC’s DGPS is connected to the GPS connector of processor unit.
[I] SBAS mode setting (Mode)
Select the satellite or the beacon whose differential information is used.
Procedures 1. Press [RADA MENU] key.
The Main Menu will appear.
2. Press [7] key.
The NAV Equipment Setting screen will appear.
3. Press [7] key.
The GPS Setting screen will appear.
4. Press [3] key.
The SBAS Setting screen will appear.
5. Press [1] key to select the satellite or the
beacon whose differential information is
used.
Beacon : SBAS receiver use the information from beacon
SBAS : SBAS receiver use the information from SBAS satellite
AUTO : SBAS receiver selects automatically
6. Press the [6] key to send the setting value to SBAS receiver.
To Next Page
Loading...
Need help?
General
