3-14
3
3) Setting another maker’s receiver or NMEA data output device
Set so that data to be received by JMA-5200MK2 is output.
Refer to “2) NMEA0183 standard input/output sentence” for the data that can be received by
JMA-5200MK2.
4) Setting the JMA-5200MK2
Set the device according to the setting on the GPS side as described in 3).
(In the standard state, the baud rate of the JMA-5200MK2 is set to 4800bps.)
In the initial state, all the sentences can be received.
When the restriction on the sentences to be received by the JMA-5200MK2 is not set, the device can be
used as it is.
However, to change the setting for selecting or restricting the sentences to be received, change the setting
as described in “4.8 COMMUNICATION PORT SETTING (COM PORT SETTING)”.
To Next Page
Loading...
Need help?
General
