4-13
[II] Reception Port Setting (RX Port)
Set the numbers of ports for receiving signals from sensors.
There are two methods for receiving signals: specifying a port for each sensor, or using the automatic
recognition function without specifying ports.
Procedures 1. Open the Adjust Menu.
2. Press [5] key.
The COM Port Setting Menu will appear.
3 Press [4] key.
The RX Port Menu will appear.
4 Select the signal you want to set,
pressing the numeric keys [1] to [6].
The Reception Port Setting Menu for each signal
will appear.
Settable signals
1. GPS
2. DLOG
3. Depth
4. Temperature
5. Wind
6. Current
7. Rate of Turn
8. Rudder
5 Select which port you want to use for output.
Types of ports to be used
1. AUTO
2. COM1 (GPS)
3. COM2 (PC)
4. COM3 (NAV1)
5. COM4 (NAV2)
*For AUTO, the initial value will be selected.
Select the number of the port to be used, pressing the numeric key.
To Next Page
Loading...
Need help?
General
