JRC JMR-5404-X - Measuring between Arbitrary Two Points

2-11 Section 2 Basic Operation
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1
2.8.2 Measuring between arbitrary two points
Here, the manipulation with EBL2/VRM2 is explained. The same operation can be performed with
EBL1/VRM1.
Memo
To manipulate the EBL/VRM, the RADAR transmission status must be “Transmit”.
1 Click on the measurement starting point button of EBL2/VRM2 and select [D].
2 Align the cursor with “point A” of the two points to be measured and then click it on.
3 Enable the movement of EBL2 by clicking on the EBL2 line.
4 Align the cursor with bearing “point B” of the two points to be measured and then click
it on.
5 Enable the manipulation of VRM2 by clicking on the [VRM2] button.
6 Move the intersecting point marker on the dotted line of EBL2 by the cursor and align it
with point B.
The range and bearing between the two points are displayed.
Memo
The measurement reference point of this equipment’s EBL/VRM can be selected from the
following three types. Set up a measurement reference point according to usage.
• Blank(CCRP) : Sets a measurement reference point at own ship’s position (CCRP).
• C(Carried) : Fixes a measurement point on the screen.
• D(Dropped) : Fixes a measurement point with longitude and latitude.
Measurement starting point button
[VRM2] button