JRC JMR-611 - Page 21

xix
3.3.2 ADJUST OPERATION PANEL BRILLIANCE [PANEL] .................... 3-7
3.3.3 SWITCH DAY/NIGHT MODE [DAY/NIGHT] ................................... 3-7
3.3.4 ADJUST BRILLIANCE OF INFORMATION ON RADAR DISPLAY
(BRILLIANCE SETTING)
.............................................................. 3-8
3.3.5 ADJUST SOUND VOLUME (BUZZER VOLUME) .......................... 3-8
3.3.6 RESET ALARM BUZZER [ALARM ACK] ........................................ 3-9
3.3.7 SET DISPLAY COLOR ................................................................... 3-9
3.4 BASIC OPERATIONS ........................................................................... 3-10
3.4.1 START TRANSMISSION [TX] ....................................................... 3-10
3.4.2 STOP TRANSMISSION [STBY] ................................................... 3-10
3.4.3 CHANGE RANGE (OBSERVATION RANGE SCALE) [+RANGE-]3-10
3.4.4 TUNE............................................................................................... 3-11
3.4.5 CONTROL SENSITIVITY [GAIN] .................................................. 3-12
3.4.6 SEA CLUTTER SUPPRESSION [SEA] ........................................ 3-12
3.4.7 RAIN/SNOW CLUTTER SUPPRESSION [RAIN] ......................... 3-13
3.4.8 INTERFERENCE REJECTION [IR] .............................................. 3-13
3.4.9 HIDE/DISPLAY RANGE RINGS [RANGGE RINGS] ..................... 3-14
3.4.10 HIDE SHIP’S HEADING LINE (HL OFF) ...................................... 3-14
3.4.11 SEA STATE (SEA STATE) ........................................................... 3-15
3.5 GENERAL OPERATIONS ................................................................. 3-16
3.5.1 MOVE CROSS CURSOR MARK BY TRACKBALL ...................... 3-16
3.5.2 USE EBLS (ELECTRONIC BEARING LINES) [EBL1/EBL2] ........ 3-16
3.5.3 USE VRMS (VARIABLE RANGE MARKERS) [VRM1/VRM2] ...... 3-18
3.5.4 USE P-LINES (PARALLEL INDEX LINES) [P-LINE] ..................... 3-19
3.5.5 MOVE OWN SHIP’S DISPLAY POSITION [OFF CENT] .............. 3-20
3.5.6 DISPLAY OTHER SHIPS’ TRAILS [TRAILS] ................................ 3-20
3.5.7 DISPLAY OWN VECTOR [OWN VECT] ....................................... 3-22
3.5.8 OWN MARK ................................................................................. 3-23
3.5.9 TIME SETTING ............................................................................ 3-24
3.5.10 CHANGE THE UNIT OF “RATE OF TURN” .................................. 3-26
3.5.11 EXPANSION ..................................................................................... 3-26
3.5.12 STC CURVE ................................................................................. 3-27
3.6 DISPLAY USER MAP ........................................................................ 3-28
3.6.1 CREATE USER MAP(MARK/LINE) .............................................. 3-28
3.6.2 CORRECT POSITION ON USER MAP (SHIFT). ......................... 3-31
3.6.3 CORRECT POSITION ON USER MAP (SHIFT CLEAR). ............ 3-31
3.6.4 SET USER MAP DISPLAY (MARK DISPLAY SETTING) .............. 3-32
3.6.5 OPERATE USER MAP FILE (FILE OPERATIONS) ..................... 3-42