3.5.8 Own Mark
Editing Own Mark Dimension
Procedures 1 Press [ MENU] key.
Main menu will appear.
2 Put the cursor on 6.OWN MARK and press [ENTER] key.
3 Put the cursor on 4.Ship Dimension and press [ENTER] key.
4 Put the cursor on 1.Own ship and press [ENTER] key.
Set the “Beam”/”Length” of own ship, the position of RADAR antenna, and the position
of GPS1/2’s sensor if you installed two sensors.
5 If there is 2nd ship (for example barge) connected to own ship, put
the cursor on 2. 2nd ship and press [ENTER] key.
Set the items. If RADAR antenna or GPS sensor is not installed on 2nd ship, set only the
dimension.
6 Press [ MENU] key.
Menu will be closed.
NOTE: Correct setting is necessary to display the vector correctly.
Display Own Mark or 2nd Ship
Procedures 1 Press [MENU] key .
Main menu will appear.
2 Put the cursor on 6.OWN MARK and press [ENTER] key.
3 Put the cursor on 3.Profile and press [ENTER] key.
4 Put the cursor on 1.Own Ship or 2.2nd Ship and press
[ENTER] key.
Select the shape (Rectangle or Pentagon) or OFF. Rectangle or Pentagon is selected, own
mark or 2nd ship’s mark will be appeared.
5 Press [ MENU] key.
Menu will be closed.
This RADAR can display ten marks or less. For addition of more ships mark display, set
from 3. 3rd Ship to 10th Ship .
To Next Page
Loading...
