JRC JMR-611 - Sea State (Sea State)

3.4 BASIC OPERATIONS


3-15
3
3.4.11 Sea State (SEA STATE)
Be careful when using the sea state function. By enabling this function, small
fast-moving objects will not be shown. If these small fast-moving objects come to
a standstill, they will be displayed again. This function should be used on open
sea.
Additionally, a warning message will be displayed at the bottom of the radar
screen once this feature is enabled.
Sea State: WINDY (Yellow)
Sea State: ROUGH (Orange)
Sea State: STORM (Red)
One of the unique functions in the JMR-611 radar is the ability to very well suppress annoying waves on open
water if a GPS compass is connected. The GPS compass information must be provided in a specific way or this
function cannot be activated.
Procedures 1 Put the cursor on SEA STATE at the lower left of the screen and
press [ENTER] key.
The sea state modes are switched.