JRC JMR-611 - Reset Alarm Buzzer [Alarm Ack]; Set Display Color

3.3 PREPARATION


3-9
3
3.3.6 Reset Alarm Buzzer [ALARM ACK]
When an audible alarm is issued, use [ALARM ACK] to acknowledge the alarm information, stop the alarm
buzzing, and stop the alarm lamp flashing. (If more than one alarm has occurred, press the switch for each
alarm indication.) The alarm stops buzzing, but the alarm indication does not disappear.
Procedures 1 Press [ALARM ACK] key.
The alarm will stop buzzing.
3.3.7 Set Display Color
Color can be changed for each item of information (shown below) on the screen by operating the menu.
1.ECHO
Change the colors of radar echoes.
2.TRAILS
Change the colors of radar trails.
3.ECHO BACK GROUND
Change the background color inside the bearing scale.
4.DATA BACK GROUND
Change the background color outside the bearing scale.
5.ROT BAR
Change the colors of ROT bar.
6.PILOT
Change the colors of the symbol of pilot.
7.RUDDER BAR
Change the colors of rudder bar.
8.OTHERS
Change the colors of characters etc.
9. OWN MARK
Change the colors of own ship mark.
10.AIS/VECTOR
Change the colors of the symbol of AIS and own ship’s vector.
11.VRM
Change the colors of VRM.
Procedures 1 Press [MENU] key .
Put the cursor on [2.COLOR] and press [ENTER] key.
The color-setting menu will appear.
2 Put the cursor on the item to be changed and press [ENTER] key.
The kinds of color menu will appear.
Select the color to be set, and press [ENTER] key.
The selected color will be set.
Exit 1 Press [MENU] key.
The menu will be closed.
Note: The display color set here are saved in accordance with the day/night mode.