N
nowensSep 7, 2025
How to enable the click sound on JRC NWZ-4610?
- Ddavid92Sep 7, 2025
If you are not hearing a click sound on your JRC Marine Equipment, check the click sound setting to ensure it is not turned off.
To Next PageTo Next PageHow to enable the click sound on JRC NWZ-4610?
If you are not hearing a click sound on your JRC Marine Equipment, check the click sound setting to ensure it is not turned off.
What to do if the JRC Monitor power does not turn on?
If the JRC Monitor doesn't power on, several factors could be at play. First, verify that the ship junction box and the power supply equipment (if applicable) are correctly supplying power by checking their cabling. If the cabling is intact, inspect the fuses connected to both the power cable and the power supply equipment, replacing them if necessary. If these steps don't resolve the issue, the display unit switch may be broken, and you should consult with JRC or our agents.
Why is there no transmission to external devices from my JRC Monitor?
If your JRC Monitor isn't transmitting to external devices, it might be due to a few reasons. You may need to configure the output settings. Also, ensure that the configured channel is correct. If the problem persists, the DISP-DPU or POWER SUPPLY UNIT might be broken, and you should consult with JRC or our agents.
General| Brand | JRC |
|---|---|
| Model | NWZ-4610 |
| Category | Marine Equipment |
| Language | English |
