Connect the battery.
The red wire is positive (+) and the
black wire is negative (-). Connect the
red clamp to the positive (+) terminal
of the car battery and the black
clamp to the negative (-) terminal of
the battery.
If the connection is successful, the LED
turns green.
NOTES:
- If the battery of the vehicle is an
old battery, the oxidation layer
must be removed before using this
product.
- Be sure to adjust your clamp for
maximum contact for both sides of
the clamp. Always check if the
clamps are well connected.
- When using the clamps, do not
allow the positive and negative
poles to contact each other. This
may cause sparking and result in a
safety hazard and cause a short
circuit of the Jumpstarter.
To Next Page
Loading...