Disconnect the jumper cables.
- When the vehicle is started,
remove first the jumper cables
from the Jumpstarter and then
remove the red and black clamps
from the vehicle battery.
- Leave the vehicle’s engine running
for a while.
- After jump-starting a vehicle, it is
recommended to recharge the
Jumpstarter before reuse.
The car still won't start?
Option 1:
Make sure the connector of the jump cables is connected with the
jump starter and the clamps are disconnected from the battery
terminals.
Press “RST” on the back of the connector until the LED turns green
(use a small pointed object to press the button). Connect the red
clamp to the positive (+) terminal of the battery and the black
clamp to the negative (-) terminal of the battery.
Now start the car.
Option 2:
Disconnect the negative (-) ground cable from the battery.
Start again with option 1 (now the negative (-) ground cable is
disconnected from the battery).
Now the car without battery will only start on the Jumpstarter.
To Next Page
Loading...