JTS CS-1 - Counter Operation; Delegate Unit Operation

12
5.4 Counter Operation
1) Pressing the “Set” button, the Date | Set area on the LED-
Display will show“Counter”
2) Pressing “Up” to start counting.
3) Pressing “Up” again to stop.
4) Pressing “Down” to clear data after stopping.
5) Pressing the “Set” button again to jump back the original
display. Notice that you can operate any other functions
of the control unit when the counter is used.
5.5 Delegate unit operation
1) Depending on the setting of the microphone mode on the
CU, pressing the microphone ON/OFF push-button will
activate the gooseneck microphone.
2) Pressing again turns the microphone off
SET
SET
SET
1..4 1..4