JUKI HZL-X Series - Replacing the Thread Trimming Blade

– 28 –
6-17-3 Replacing the thread trimming blade
1. Remove the throat plate.
2. Remove the setscrew of the thread trimming knife cover. Remove the thread trimming knife cover, the
thread trimmer grasping unit and the thread trimming knife.
 3.Reversingthedisassemblyprocedure,assembletheparts.(RefertotheCautionbelow.)
(Caution) When assembling the thread trimmer grasping unit, put its pin into the slit in the thread trimmer
link at the lower side of the mechanism section as illustrated below. Thread trimming cannot be
performed if the pin has not entered the slit.
Setscrew of the thread trimming
blade cover
Thread trimming blade cover
Thread trimmer grasping unit
Thread trimming blade
Put the pin of the thread grasping unit
into the slit of the thread trimmer link.