JUKI HZL-X Series - Page 36

– 34 –
6-20-3-2 Adjusting the presser foot height to 6 mm
Adjustmentprocedure
 1.Select"No.22:6MMSETTING"oftheservicemode.
  Atthistime,checktobesurethatthefeeddogdoesnotappearabovethetopsurfaceofthroatplate.
 2.When"No.22:6MMSETTING"isselected,thepresserfootgoesupbyapproximately6.5mm.
  Ifnot,turnthestitchlengthadjustingdialinthe"+"directioninthecaseoftheDX7model,orpressthe
stitchlengthadjustingbuttoninthecaseoftheDX5modeltoliftthepresserfootbyapproximately6.5mm.
 3.Placeablockorthelikethicknessofwhichis6mmunderthepresserfoot.Operatethesewingmachine
inincrementsof1pulseinthe"-"directiontolowerthepresserfootuntilitsverticalplayiseliminated.
* Be sure to adjust the presser foot height by lowering it from its upper position. If you excessively
lower the presser foot, lift the presser foot again by approximately 6.5 mm.
 4.Pressthe"OK"button.
⇦
⇦
20 : MODEL SELECT
21 : 0MM SETTING
22 : 6MM SETTING
23 : – – – – – –
(851)
20 : MODEL SELECT
21 : 0MM SETTING
22 : 6MM SETTING
23 : – – – – – –
(851)
6.5 mm
6 mm block
The presser foot has
no vertical play.
6 mm block