- 12 -
(3) Programmed stitching pattern
The constant-dimension stitching process can be programmed as many as 20 operation steps. The sewing
conditions including the number of stitches, needle up/down stop mode, automatic thread trimming,
continuous operation steps, lifting/lowering of presser foot and normal/reverse feed stitching can be
separately specified for the respective operation steps. If the lifting of presser foot is specified, the time
during which the presser foot is raised can be also specied.
Programming procedure is described below
taking the pattern on the left side as an example.
Press to display the pattern list screen.
1) Press switch
1
to select the programmed stitching pattern, and the screen is automatically changed over
to the programmed stitching setting screen to display the number of stitches and data on the operation
step 1 which have already been specied.
[Step 1]
Example of programmed stitching pattern
Step 4
4
4
4
4
20 20
10
Step 3Step 1
Step 2
10
1
3 5 7 9
!1
2 4 6
8
!0