JUKI KE-2060R - Replacing the FDD (Floppy Disk Drive)

KE-2050/KE-2060, KE-2050R/2055R/KE-2060R Maintenance Manual
13-2
13-2. Replacing the FDD (Floppy Disk Drive)
(1) Remove the bolts  to detach the FDD support from the base frame.
(2) Disconnect the FDD relay cable connector from the FDD.
(3) Remove four screws  at the lower portion of the FDD to detach the FDD from the FDD
support.
(4) Remove two screws  on both sides of the FDD to detach the FDD face plate from the FDD.
(5) Reassemble the components in the reverse order of disassembly.
 FDD face plate 1
 HDD access lamp 1
 FDD support 1
 Air pressure meter assembly 1
 FDD 1
 SEMS cap bolt (M3 × 8) 6
 Nut (M3) 2
 SEMS cap bolt (M6 × 12) 2
Figure 13-2-1
Rev. 2.00