JUKI KE-760 - ATC (Auto Tool Changer) Unit Preparation

- 8
-
4. ATC(Auto Tool Changer) Unit
q Fix the nozzle on the ATC unit.
w Align the hole of the ATC base with that of the slide plate, then put the tie-up belt
through these holes. Tighten the tie-up belt. Make sure that the slide plate is fixed
and all nozzle cannot be removed.
e Cover the nozzle with air cap so that it cannot move, then paste adhesive tapes over
the air cap to fix them.
Figure4.1
ATC base
Tie-u
p
belt
Slide
p
late
Hole
Air ca
p
Nozzle