JUKI LK-1903A - 8. Thread Tension Command Adjustment; 8-1 Adding or Changing Tension Command

25
8. CHANGING THREAD TENSION COMMAND AT EVERY NEEDLE ENTRY POINT
8-1 Adding or changing thread tension command at every needle entry point
① Display the thread tension command change screen
Press THREAD TENSION button
(A) in the
sewing screen when users’ pattern is selected to display the
thread tension setting screen. Press THREAD TENSION
COMMAND CHANGE button
(B) on the thread
tension setting screen and the thread tension command
change screen is displayed.
② Specify the command position you desire to change.
Specify the position you desire to add the thread tension
command or that you desire to change the thread tension
command value with ONE STITCH BACKWARD button
(C) or ONE STITCH FORWARD button (D) in
the state that the presser is lowered.
In addition, the machine moves to the needle entry point
where the front or rear thread tension command exists with
(E) or (F). When you desire to stop the move,
press STOP button
(G).
When ORIGIN MOVE button
(H) is pressed, the
machine moves to the origin.
The value to be displayed is the absolute value (thread
tension value + thread tension command value).
B
A
The sewing machine does not start even when
the foot switch is depressed under this mode.