50
16-2 Selection by means of the shortcut button
① Display the data input screen or the
sewing screen.
When the pattern is registered to the folder,
pattern buttons (A) are surely displayed on the
lower side of the screen of the data input
screen or sewing screen.
② Select the pattern No.
Pattern button is displayed with every folder
which is specified when the pattern is newly
created.
When FOLDER SELECTION button
(B) is pressed, the pattern button to be
displayed is changed.
Display and press the button of the pattern
button No. you desire to sew. When it is
pressed, the pattern button No. is selected.
A
B
1. Make sure without fail of the contour of
the sewing pattern after selection of the
sewing pattern. If the sewing pattern
extends outside the work clamp feet, the
needle will interfere with the work clamp
feet during sewing, causing dangerous
troubles including needle breakage.
2. When the sewing screen is displayed
and pressing P1 to P50 keys, the presser
comes down. Be careful not to allow the
fingers to be caught in it.
To Next Page
Loading...
