JUKI MO-4s - Attaching the foot control; Sewing speed; Assembling the thread stand; Thread cones

15
ON
I
O
OFF
B
A
D&(
%
Plug foot control into machine
socket (A) and then into main
socket (B).
The sewing speed can be
adjusted by increasing or
decreasing the pressure on the
foot control ( C ).
Raise the support rod fully,
turning slightly until the
positioning catches engage.
The anti-vibration cone should be
used with the wider edge to the
bottom on the spool holder pin when
sewing with cones. When using
household spools remove the
anti-vibration cones. Place spool
on spool holder pins and push the
spool caps on.If threads slip and get
twisted, cover the spools with the
nets supplied in the accessory box.
The power switch is conveniently
placed on the handwheel side of
the machine.
"I" - ON
"O"-OFF
&
(#

D