JUKI MO-6000S series - Installing Position of the Needle Clamp; Adjusting the Length of the Lower Looper Holder (Applicable Only to MO-6 16 S; MO-6916 R, G, J Series)

−10 −
(3) Installing position of the needle clamp
Needle clamp connecting stud 1 should fit with the bottom end of needle bar 2 or spaced within 0 to
0.5 mm.
Standard Adjustment
(4) Adjusting the length of the lower looper holder
(Applicable only to MO-6 16S / MO-6916R, G, J series)
The center-to-center distance should be 26 mm.
At this time, the clearance between the end surface of the arm and the neck of the ball should be
3.5 mm.
3.5 mm
0 to 0.5 mm
Butt the needle clamp with the
bottom end of the needle bar.
26 mm
1
2
3
4
1