JUKI MO-6000S series - Upper Looper; Center-To-Center Distance of the Upper Looper Holder; Caution in Assembly; Application of Sealant

−69 −
(3) Center-to-center distance of the upper looper holder
The center-to-center distance of upper looper holder 1.
(Caution) * (asterisk) marks are exclusive for
to the MO-6900G(J). They are not
common to the MO-6000S(R) series.
(4) Caution in assembly
1) Application of sealant
1 Setscrew of the throat plate base (B) retainer 2 (JUKI seal)
Apply the sealant only to the right setscrew.
2 Bottom surface of the upper looper guide support 3 (Three-bond 1104)
Apply the sealant to the bottom surface of the upper looper guide support 3, which contacts with the
frame surface.
3 After assembling the front edge of the upper looper guide support 3 (Three-bond 1212), apply the
sealant to the gap of the contact surface between the frame and the upper looper guide support 3
( section in the illustration).
Model
MO- 6 04S(R) - -
6 05S - - 0
MO- 6 04S(R) - 0D4 to 0E4 4 H
0F6 50H
MO- 6 12S -CE4 -40H
MO- 6 12S -D -
MO- 6 14S(R) - -
MO- 6 16S(R) - - 0
BE4
DD to FF
MO- 6943R - - 7
MO- 6 43S - -40H
MO- 6903G -0N6 -3D1
MO- 6904G(J) -0F6 -700
700
7E0
MO- 6914G(J) -CH6 -700
FH6
FF6
Center-to-center distance H
38
39
38
39
39
38
39
39
39
*39
37.5
*39
37.5
37.5
MO- 6 16S(R)- -
MO- 6916G (J) - -700
Apply only to
the right
setscrew
Apply the sealant to the
bottom surface.
12345678
1
234567
8
1
234567
8
12345678
Frame
Be careful not to allow the
sealant to run to the rear.
Apply the sealant to
bottom surface.
(Unit : mm)
1
H
2
3
-
MO- 6905G -0M6 -
4 H
5 H