−30 −
#5 Selection of thread trimmer and additional device (Function setting No.65)
Thread trimming control corresponding to the machine head is selected. When additional device is
mounted, device function is set.
65
FUn
FUn
TrM
TrM : This is setting when using thread trimmer mechanism built in the machine head. Models for which this
setting is possible are as described below.
LED 4-digit display Applicable model Remarks
no p Setting invalid
L151Machine head of LU-151** series
LU22Machine head of LU-22** series
L152Machine head of LU-152* series
d639DLN-6390
LED 3-digit display
Tr.0
LED 4-digit display
End End of setting (Setting returns to the
normal function setting.)
TrM Selection of thread trimmer function
UT1 Setting of additional device 1 function
UT2 Setting of additional device 2 function
LED 3-digit display
FUn
1
2
4
3
Setting item is selected by operating 3 and 4.
Setting item is determined by operating 1 and 2.
(Caution) Contents of thread trimming function can be automatically set as well at the time of the
function setting. Therefore, it is not necessary to set the function normally.
To Next Page
Loading...
Need help?
General
