JUKI SC-510 - SC-510 Function Settings

－
16
－
(3) Special setting
For material end sensor function, automatic thread trimming function, one-shot automatic stitching
function and thread trimming prohibition function which are displayed in the front panel, it is possible to
change the set value by directly moving to the function setting mode while the power is turned ON in ad-
dition to the normal function setting procedure.
[ Moving procedure to the function setting mode ]
1) Hold pressing / switch
1
, and press
switch
3
to move to the function setting
mode.
(Caution) Function setting No. 2 is displayed imme-
diately after the changeover.
2) When returning to the normal mode, press /
switch
2
and determine the contents of
the setting.
1
Material end sensor function setting (Function
setting No. 2)
It is rendered effective when connecting the op-
tional material end sensor.
It is possible to change the set value with
switch
3
or switch
4
.
0 : Material end sensor function is prohibited.
1 : Material end sensor function is effective.
2
Thread trimming operation after material end
stop setting (Function setting No. 3)
Press
/ switch
1
to advance to the
function setting No. 3.
It is possible to change the set value with
switch
3
or switch
4
.
0 : Material end stop
1 : Automatic thread trimming after detection of
material end
When "1" is selected, material
end sensor display lights up
when the mode has returned to
the normal one.
When "1" is selected, the auto
-
matic thread trimming display
lights up when the mode is re-
turned to the normal one.
1
3
1
3
4
1
3
4
2