Need help?Do you have a question about the JUMO 404304 Series and is the answer not in the manual?
General| Brand | JUMO |
|---|---|
| Model | 404304 Series |
| Category | Transmitter |
| Language | English |
Defines warning symbols like Danger and Caution for personnel and equipment safety.
Defines note symbols for remarks and references to further information.
Instructions to read manual, keep accessible, and provide suggestions for improvement.
Details instrument use for low pressures, diaphragm sensitivity, and gas compatibility.
Explains how to identify the device through order codes for type, extensions, and ranges.
Instructions on how to fix the instrument vertically to ensure proper operation and prevent condensate ingress.
Details on connecting power supply and output signals for 3-wire and 2-wire configurations.
Describes measuring the output signal, warm-up time, and zero point adjustment.
Lists necessary equipment for calibration: pressure generator, reference device, and multimeter.
Details the setup for calibration, including connection diagrams and the calibration steps.
Overview of limit contact controls (GK1/GK2) and terminal descriptions.
Steps for preparing the instrument and defining switching ranges for limit contacts.
Configuring relay function and setting limit contacts using a pressure measuring device.
Procedure for setting limit contacts and hysteresis using a multimeter.
Instructions for setting the switch-on and switch-off delays for limit contacts.
To Next Page
