Need help?Do you have a question about the JUMO dTRANS T02 LCD and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Protection Type | IP65 |
| Storage Temperature | -40 to +85 °C |
| Measurement Range | Depends on the sensor used |
| Input Type | Thermocouple |
| Output Type | Analog output |
| Power Supply | 24 V DC |
| Housing Material | Plastic |
Visual representation of all electrical connections for the device.
Critical safety and installation practices related to electrical connections, fields, and cable routing.
How to access and modify operational parameters.
How to access and modify fundamental configuration parameters.
Explains the specific "Teach-in" parameter for defining zero values.
How to adjust limit comparators (AL1, AL2) and hysteresis values, and monitoring functions.
How to configure fault outputs based on detected errors like probe break or overrange.
How to use the open-collector output 2 for frequency signal output.
Adjusting zero point (OUTL) and full scale (OUTH) for accurate signal output, and resetting.
A practical example demonstrating the use of the Teach-in function for zero point calibration.
Table listing parameters like limit values and calibration settings.
Lists parameters that can be configured using the PC setup program.
Example of interfacing the device with a PLC's digital input.
Example illustrating how to connect an external relay to the device's open-collector output.
To Next Page
