JUMO dTRANS T02 LCD - Value Adjustment and Verification; Teach-in Parameter Function

15
4 Functions and operation
Incrementing values
When programming the parameters, the i button is used to in-
crease a value (+).
Decrementing values
When programming the parameters, the d button is used to de-
crease a value (-).
Accepting values
If a setting has been altered, the q button has to be pressed to ac-
cept the alteration.
q has a twofold function:
- Acceptance of altered values
- Calling the next parameter
Value check
With the exception of the parameters OUTL, OUTH and OFFS, all
present values can be checked during programming by means of
the LC display.
When setting OUTL, OUTH and OFFS, the actual value is shown in the
LC display.
H
Please note that the programming of the “Teach-in” para-
meter deviates from the standard operation.
v See “Teach-in” on page 20.