JUNCTEK JDS8000 Series User Manual

JUNCTEK
JDS8000 Series User’s Manual
9
 CH2 button
Output switch for controlling CH2.
Press the CH2 button, the CH2 channel indicator lights up, and the CH2 output
is enabled. At this time, the CH2 connection port outputs the signal with the
current configuration.
Press the CH2 button again, the CH2 channel indicator is off, and at this time,
the CH2 output is turned off. When the input box is open, it is the number key
9.
 OUT button
Output switch for simultaneously controlling CH1 and CH2. When the input box
is enabled, it is the number key 7.
(3) Signal Input Connectors
 EXT.IN signal input connector
Input signal voltage range 1Vpp~20Vpp.
 MOD.IN modulation input connector
Input signal voltage range 0Vpp~3Vpp.
(4) Signal Output Connectors
 CH1 output connector
BNC connector with 50Ω±10% nominal output impedance.
When CH1 is enabled (the backlight turns on), this connector outputs
waveform according to the current configuration of CH1.
 CH2 output connector
BNC connector with 50Ω±10% nominal output impedance.
When CH2 is enabled (the backlight turns on), this connector outputs
waveform according to the current configuration of CH2.
(5) Arrow keys
Used to move the cursor to select the digit to be edited when setting
parameters.
Used to delete the values at the left of the cursor when inputting values using
numeric keyboard.
(6) Knob
Used to increase (clockwise) or decrease (counterclockwise) the value marked
by the cursor when setting parameters using knob.
Used to quickly switch waveforms when the waveform bar is activated.
(7) Function shortcut keys
It consists of numeric keys (0 to 9), decimal point (.) and sign key (+/-) to set
parameters.

JUNCTEK JDS8000 Series Specifications

General

Brand	JUNCTEK
Model	JDS8000 Series
Category	Security Sensors
Language	English