79
for setting up a radio connection/group.
After the red radio LED goes off, you
can begin the set up of a radio group.
3. In order to be able to build a group
of several inter-connected smoke alarm
devices with radio links (radio group),
the master function needs to be activa-
ted in the rst activated smoke alarm
device with radio link.
Please always remember that this rst
smoke alarm device with radio link will
manage the structure of the radio group
in future and therefore a central installa-
tion position needs to be found for it.
For activating the master function in this rst
activated smoke alarm device with radio link,
press the radio button (Illus. 6 point a) with
the long and thin pin-end of the activation
fuse (Illus. 5) until the radio LED lights yellow.
Pull out the pin and keep it handy.
The radio LED will now change into a
short, yellow interval and then shows a
green signal to conrm to you that the
smoke alarm device with radio link has
been successfully assigned the master
function.
After this green conrmation, the radio
LED changes to a regular, long, yellow
interval which shows that the connec-
tion mode of the rst smoke alarm de-
vice with radio link (master), is now ac-
tive and the device is ready to connect
to other smoke alarm devices with
radio links to form a radio group.
You can now continue with laying out a
radio group.
You have approximately 10 minutes to
activate the connection mode in ano-
ther smoke alarm device with radio
link, thereby building a radio group.
en
To Next Page
Loading...
Need help?
General
