Juniper ACX7024 - Description

position-mode {
position-fix-mode (latitude | longitude | altitude);
survey-mode (survey-length);
}
receiver-type;
snr-threshold
}
Hierarchy Level
[edit chassis synchronization]
Descripon
Congure GNSS receiver with ACX7024 router. The GNSS receiver receives signals from a navigaon satellite
constellaon. The receiver gains precise phase and me informaon by processing these signals and delivers the
informaon across the packet network.
Opons
cable-delay-compensation—GNSS receiver unit to router RF cable delay compensaon in nanoseconds. You can specify a
value in nanoseconds to compensate the delay that the cable introduces.
• Range: -1000000 through 1000000 nanoseconds
constellation—Various constellaons are available. You can congure the GNSS receiver to explicitly use a specic
constellaon or combinaon of constellaons.
The following constellaons are available:
•
gps: Enables detecon and locking to the GPS constellaon.
GPS signals enable you to determine the posion of the receiver on earth and maintain a high level of me accuracy.
The GPS L1CA receiver with 10MHz clock frequency output synchronized to a GPS satellite.
NOTE: You can use only GPS L1CA to congure the GNSS receiver.
•
galileo: Enables detecon and locking to the GALILEO constellaon.
19