Juniper ACX7024 - Required Privilege Level

• glonass: Enables detecon and locking to the GLONASS constellaon.
• qzss: Enables detecon and locking to the QZSS constellaon.
interface—Enable/Disable GNSS port/slot communicaon.
NOTE: For ACX7024 router, only one port of GNSS receiver is supported.
position-mode—GNSS receiver's posion modes. You can congure two posion modes of GNSS receiver— position-fix-
mode and survey-mode.
• position-fix-mode: Use this mode when you know the accurate antenna locaon.
• Latitude— Latude in degrees.
• Range: -90.0000000 to 90.0000000 degrees
• Longitude— Longitude in degrees.
• Range: -180.0000000 to 180.0000000 degrees
• Altitude— Altude in meters.
• Range: -1000 to 18000 meters
NOTE: Be cauous when you use this mode. Ensure that you congure the correct posion. Conguring the
wrong posion might cause erroneous receiver funcon and faulty grandmaster clock performance.
• survey-mode: Use this mode when you do not know the xed locaon of the antenna.
GNSS receiver does a self survey of its own posion for a period menoned in survey length and then moves to
posion x mode. This is the default mode and the default survey length is 120 minutes.
receiver-type— Only TB-1 is supported as the GNSS receiver.
snr-threshold— GNSS receiver measures the Signal-to-Noise Rao (SNR) value to indicate the signal strength of the
received satellite signal and the noise density. You can congure the SNR threshold value. You can perform posioning
by using only those satellites that have signal level equal to or above the threshold value with a range of 0 to 99 dBHz.
Required Privilege Level
interface—To view this statement in the conguraon.
interface-control—To add this statement to the conguraon.
20