Juniper CTP2000 Series Hardware Guide

NOTE: To provide redundancy, do not use the same power source for Power A and Power
B leads.
8. Repeat Steps 1–7 for each power supply module in your configuration.
RELATED DOCUMENTATION
CTP2000 Management Ports | 110
Cabling a CTP2000 T1/E1 Interface Module | 111
Required Tools, Wires, and Cables for the CTP2000 Platform | 109
Terminal Block and Circuit Breaker Specifications | 69
114

Juniper CTP2000 Series Specifications

General

Brand	Juniper
Model	CTP2000 Series
Category	Network Hardware
Language	English