Juniper CTP2000 Series - Powering off the CTP Platform

During initial power-on, the components of the platform run boot code, go through a series of self-diagnostic
tests, and synchronize with each other.
When the tests are complete, use the LEDs on each module to determine the status of the device. Observe
the module LEDs on the front or rear components.
RELATED DOCUMENTATION
Before You Power On the CTP2000 Platform | 115
Powering Off the CTP Platform | 119
Powering Off the CTP Platform
se to power device
1. From the Main Menu, select 5) Node Operations.
2. From the Node Operations Menu, select 10) Powerdown Node.
119