To Next Page

To Previous Page

Ctp circuits can run over any ethernet device, default or not.

A default device must be configured, other devices may be configured

and enabled, or disabled. Here is a list ot the available devices

and their descriptions:

eth0: 10/100/1000 Copper (front)

eth1: 10/100/1000 Copper (back)

eth2: 1000 Fiber (left)

eth3: 1000 Fiber (right)

What device would you like to make the IPV4 default device? (rtn for eth0): eth1

OK, eth1 (10/100/1000 Copper (back)) will be configured as IPV4 default device.

Please input the hostname (return for (none)): nova_54

===== Configuration for eth1 (default device):

Please input the ip (return for 127.0.0.1): 172.25.61.54

Please input the netmask (return for 255.255.255.0): 255.255.255.128

Please input the gateway (return for 127.0.0.1): 172.25.61.1

Please input the mtu in bytes (return for 1500):

Add route to interface eth1 [n]

======================================

=== OS Security level set to LOW ===

======================================

************** Setting up date/time *****************

Setting the date (GMT). Please input the year [2008-2020] (return for 2010):

Setting the date (GMT). Please input the month [1-12] (return for 01):

Setting the date (GMT). Please input the day [1-31] (return for 11):

Setting the date (GMT). Please input the hour [0-23] (return for 20):

Setting the date (GMT). Please input the minute [0-59] (return for 22):

INIT: Entering runlevel: 3

Entering non-interactive startup

...

118

Juniper CTP2000 Series Hardware Guide

Other manuals for Juniper CTP2000 Series