Juniper CTP2000 Series Hardware Guide

2. Place the side edge of the tray housing in the fan tray compartment, and push toward the back of the
chassis until the tray stops.
An electrical connector on the back of the fan tray pairs with an electrical connector at the back of the
shelf.
3. With an appropriate screwdriver, tighten the captive screws.
Alternate between screws when tightening them to ensure that the electrical connectors at the back
of the tray fit tightly.
RELATED DOCUMENTATION
Removing a CTP2000 Fan Tray | 133
134

Juniper CTP2000 Series Specifications

General

Brand	Juniper
Model	CTP2000 Series
Category	Network Hardware
Language	English