Juniper E Series Configuration Guide

JUNOSe 7.2.x Policy Management Configuration Guide
128 ! Policy Management show Commands
! To display information about tunnels on a specific virtual router, include the
name of the virtual router.
! Field descriptions related to policies
! GRE tunnel policy input—Policy for outbound traffic
! GRE tunnel policy output—Policy for inbound traffic
! traffic-class—Name of traffic class
! classifier-group—Name of classifier group
! entry—Identifier for the entry in the classifier group
! packets—Number of packets
! bytes—Number of bytes
! mark—ToS byte setting for the classifier control list
! mask—Mask value corresponding to the ToS
! Example
host1#show gre tunnel detail tunnelGre50
GRE tunnel tunnelGre50 is Down
Tunnel operational configuration
Tunnel mtu is '10240'
Tunnel source address is '0.0.0.0'
Tunnel destination address is '0.0.0.0'
Tunnel transport virtual router is source
Tunnel checksum option is disabled
Tunnel sequence number option is disabled
Tunnel up/down trap is enabled
Tunnel-server location is 6/0
Tunnel administrative state is Up
Statistics packets octets discards errors
Data rx 0 0 0 0
Data tx 0 0 0 0
GRE tunnel policy input routeGre25
classifier-group gre6 entry 1
0 packets, 0 bytes
traffic-class best-effort
mark 4 mask 255
GRE tunnel policy output routeGre35
classifier-group gre14 entry 1
0 packets, 0 bytes
traffic-class best-effort
mark 4 mask 255
show interfaces
! Use to display information about a subinterface and its VLAN policy lists.
! You can specify the following keywords:
! delta—Specifies that baselined statistics are to be shown
! brief—Displays the operational status of all configured interfaces

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English